This American tandem rotor, heavy-lift helicopter was first used during the Vietnam War. Powered by two 4,733 horsepower turbo-shaft engines, it has a top speed of 196 mph which made it faster than any other utility and attack helicopter at that time. It remains in production and frontline service, with over 1,200 built to date.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
2 sheets of metal

1.25 sheets

The Chi Ha tank was built by Mitsubishi and designated the CHI-HA. It used the Mitsubishi air-cooled 170 horsepower diesel engine and was regarded as the best tank that Japan had produced during World War II. The main armament consisted of a single 57mm gun mounted in the turret and supported by two 7.7mm self-defense machine guns.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
2 sheets of metal

These amazingly detailed DIY models start as square steel sheets and finish as amazing 3D models.. Use the easy to follow instructions to pop out the pieces, bend the tabs, and connect them at the attachment points.
Build your collection today!
2 sheets of metal

These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
1 sheet of metal

This wide-body commercial airliner and cargo transport aircraft is often referred to as a Jumbo Jet. It first flew Feb. 9th, 1969 and has become one of the world's most recognizable aircraft.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
1 sheet of metal

Is a crane that is mounted on top of a tracked vehicle. They all feature large counterweights set on the back of the crane that allows them to lift and move very heavy loads without tipping over. Their lifting capacity ranges from 30 to 3000 tons.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
2 sheets of metal

The Steam Locomotive is a train that produces its power from a steam engine. The train must carry its water either in the locomotive itself or in an attached car behind the locomotive. The steam is produced by burning coal, wood or oil. Steam engines dominated railway transportation from the early 19th century through the middle of the 20th century.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
2 sheets of metal