This was Packard’s flagship. It was the car positioned to take on the best from Cadillac and Lincoln throughout the depths of the Great Depression. It was named for its 12 cylinder engine, which was ideal to power Packard’s top model.
2.5 sheets

Ushered in a new class of automobile known as the pony car. Its revolutionary design featuring the long hood and short deck proved wildly popular and according to Ford, 22,000 orders were taken the day it debuted. The Mustang featured a base 170-cubic inch six-cylinder engine with a three-speed floor shift transmission, full wheel covers, bucket seats, carpeting, and a padded dash all for a base retail price of $2,320. An optional 260-cubic inch V-8 engine was also available.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
2 sheets of metal

The first-generation Ford Mustang was manufactured by Ford from March 1964 until 1973. The introduction of the Mustang created a new class of automobile known as the pony car. The Mustang’s styling, with its long hood and short deck, proved wildly popular and inspired a host of competition.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
2 sheets of metal

Originally produced by McDonnell Douglas, this Boeing twin-engine army attack helicopter first entered service with the US Army in 1984. Since then it has become the primary attack helicopter of many nations. More than 2,000 have been produced.
These amazingly detailed DIY models start as 4” square steel 3D models. Simply snip out the pieces and bend the tabs through corresponding connection points. Easy to follow instruction included. Tweezers or small needle nose pliers are suggested to facilitate assembly.
2 sheets of metal

The Apollo 11 moon landing required two spacecraft- The lunar module (LM) and command service module (CSM). Once in lunar orbit, the two would separate so the LM could land while the CSM waited in orbit. After launching from the lunar surface, the LM’s ascent stage would rendezvous and dock with the waiting CSM, then the astronauts would transfer back into the main spacecraft and head home. It sounds nearly impossible but that’s the way it was July 20, 1969.
3.5 sheets

These amazingly detailed DIY models start as square steel sheets and finish as amazing 3D models.. Use the easy to follow instructions to pop out the pieces, bend the tabs, and connect them at the attachment points.
Build your collection today!
2 sheets of metal